The Mud Pit > Wrenching

round, flush mount tail lights

<< < (5/5)

rocket:

--- Quote from: RUSKIE on February 09, 2008, 05:30:08 PM ---'They' make a bit for your drill that does a great job on sheet metal. 

It is basically a circle cutter, where an arm attached to a center shaft allows you to move the carbon steel bit out to whatever diameter you want.  It makes a nice, clean cut, too.  Goes through aluminum like butter and is suitable for auto body metal.  It's perfect for dash gage/meter installation.


--- End quote ---

I've used a similar bit in wood working, but only in a drill press, since it was not fully ballanced.  how well does the one you used work in a hand drill?

Navigation

[0] Message Index

[*] Previous page