The Mud Pit > Wrenching

round, flush mount tail lights

(1/5) > >>

albsvx:
Hey Reg,
What'd you use to cut your tail lights in?

Cheek-Bone:
Al, I have used a dremel and cutting wheel but that is kinda tough. The easiest way is to get a 4" hole saw but they are like $30. But Reg used a keyhole saw and it worked really good.

reg:

--- Quote from: Cheek-Bone on January 20, 2008, 02:09:43 PM ---Al, I have used a dremel and cutting wheel but that is kinda tough. The easiest way is to get a 4" hole saw but they are like $30. But Reg used a keyhole saw and it worked really good.

--- End quote ---

yup, ye olde jig saw

reg:
the wireing can be a bear, i recommend cutting the wires between the plug and the light.  this way your tail lights can be removed eaiser.

Cheek-Bone:
Here is a great write up that shows everything from where to cut the holes to which wires do what. Hope it helps, it is the one I used when I did mine on the Blue YJ.

http://www.jeepaholics.com/tech/flushlights/

Navigation

[0] Message Index

[#] Next page