Author Topic: Welcome to the JT4x4 Club Forums........  (Read 101915 times)

Offline Caddydaddy

  • Trail Passenger
  • *
  • Posts: 8
Re: Welcome to the JT4x4 Club Forums........
« Reply #285 on: December 03, 2014, 04:01:41 AM »
Hello,
  I'm Sean and live in Gales Ferry.  I have a '07 Jeep Grand Cherokee Diesel.  This is my first Jeep and my first 4x4.  I bought it as a tow rig and something to get through the snow since I knew I was moving North.  I bought a diesel because I didn't want something that sucked down fuel.  I'm loving the 19 MPG average and 25 MPG on the highway it gets!
  Other than an engine tune and some other small engine mods, my Jeep is stock.  I've heard a lot of good things about how well the Quadra-Drive II handles off-road, even stock, so I'm curious to try it out!
2007 Jeep Grand Cherokee Limited CRD
2" lift, 255/70/17 General Grabber AT2s
Rock rails, skids and a Green Diesel Engineering tune for more power!

Offline Mr Rock

  • Administrator
  • Trail Master
  • *****
  • Posts: 1571
Re: Welcome to the JT4x4 Club Forums........
« Reply #286 on: December 03, 2014, 04:36:37 AM »
Welcome aboard to Sean!

both of you!
'89, 4.2, NUTTERED, Team Rush, 4" Lift, 1" BL, 1" MML & HD shackles , Flat Belly Skid, SYE, 36 x 13.50s
XRC8, 150w KC's, Herculined, Tauras Elec Fan, Dual Batteries, Aussie in front, 8.8, TJ flares & Spool in rear, topless all of the time!

Offline calvynandhobbs

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 3087
Re: Welcome to the JT4x4 Club Forums........
« Reply #287 on: December 03, 2014, 01:54:01 PM »
Welcome aboard Sean and Sean.
1994 YJ on 37s

Offline Mayhem

  • BANNED
  • Rock Crawler
  • *****
  • Posts: 336
Re: Welcome to the JT4x4 Club Forums........
« Reply #288 on: December 03, 2014, 04:46:00 PM »
Welcome, Sean and Sean. ;D
Greg
Model Citizen

Offline Mreecew

  • Rock Crawler
  • ****
  • Posts: 256
  • Bonzai Samurai!!!!
Re: Welcome to the JT4x4 Club Forums........
« Reply #289 on: December 03, 2014, 05:06:17 PM »
Welcome Welcome!
1991 Samurai, 1.3 TBI, 35" KM2's, full 2 1/4" exhaust, SOA, RUF, Trail Tough Belly Skid, 5k Winch, Locked front and rear, GRS-2 transfer case gears (4.89:1 low), Built front axle with trusses, guards, gussets and birfield rings, Shrockworks gas tank skid, junk body and not much of a top.

Offline Caddydaddy

  • Trail Passenger
  • *
  • Posts: 8
Re: Welcome to the JT4x4 Club Forums........
« Reply #290 on: December 04, 2014, 12:30:49 AM »
Welcome, Sean and Sean. ;D

Thanks!  I guess I'll have to change my name to something else.  Call me Fred! haha
2007 Jeep Grand Cherokee Limited CRD
2" lift, 255/70/17 General Grabber AT2s
Rock rails, skids and a Green Diesel Engineering tune for more power!

Offline Big Chuck

  • President
  • Trail Master
  • *****
  • Posts: 730
Re: Welcome to the JT4x4 Club Forums........
« Reply #291 on: December 04, 2014, 04:31:20 AM »
Welcome to both of you!
Tube chassis, 5.3LS, Ford Dana 60 Chevy 14 Bolt 5.13 gears. 203/205 doubler, Hydro steering, air shocks, 42 inch Iroks on 16.5 H1 double bead locks.

Offline JSchwinn

  • Trail Queen
  • **
  • Posts: 76
Re: Welcome to the JT4x4 Club Forums........
« Reply #292 on: January 02, 2015, 05:55:35 PM »
Hey guys wanted to re-introduce myself.  My names Josh and I joined the forum awhile back but havent really been active.  I recently sold my '72 CJ5 which wasn't really going to work for offroading and purchased a '93 YJ, it is a straight 6, has 4" lift and 3" body lift(which is about to get reduced to 1") and has 33's.  I live in Gales Ferry and look forward to meeting up soon.
1993 YJ - I6 - 4" RC Lift - 8k Winch - 33's

Offline Mayhem

  • BANNED
  • Rock Crawler
  • *****
  • Posts: 336
Re: Welcome to the JT4x4 Club Forums........
« Reply #293 on: January 02, 2015, 09:52:58 PM »
Welcome back, Josh!
Greg
Model Citizen

Offline calvynandhobbs

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 3087
Re: Welcome to the JT4x4 Club Forums........
« Reply #294 on: January 02, 2015, 10:13:48 PM »
Welcome back Josh. I was prepping things for the upcoming meeting and was wondering where you had gone to. There were a few of you that came to a meeting or two or a wheeling event and then disappeared.
1994 YJ on 37s

Offline JSchwinn

  • Trail Queen
  • **
  • Posts: 76
Re: Welcome to the JT4x4 Club Forums........
« Reply #295 on: January 04, 2015, 03:46:54 PM »
Welcome back Josh. I was prepping things for the upcoming meeting and was wondering where you had gone to. There were a few of you that came to a meeting or two or a wheeling event and then disappeared.

Yea my '72 had manual brakes/steering and it just wasn't going to be up for offroading, plus it is one of the few cj5's I've seen with zero rust/rot and couldn't bring myself to beat it up too much along with the fact it was really only a summer toy.  So I sold it and bought a YJ that I'll be able to drive year round.  The YJ needs a few things done to it but overall it is rust/rot free(came from florida a few years ago) need to replace one wheel cylinder and the rear driveshaft ujoints.  Once that's done I should be good to go.
1993 YJ - I6 - 4" RC Lift - 8k Winch - 33's

Offline toreadorranger

  • Paid Members
  • Mudd Hog
  • ***
  • Posts: 235
Re: Welcome to the JT4x4 Club Forums........
« Reply #296 on: April 07, 2015, 06:53:14 AM »
New to the forum, From Salem.  I have a project that has gotten out of control.  What started as a half ton Solid axle swap for my Ranger, has morphed into a full on buggy build.  Swapped the 1/2 tons for D60/D70 combo, then bought a set of 47" LTBs, so the 1tons got swapped for a set of steering rockwells, then decided I wanted a 4 seater so the frame and cab got scrapped and a Bent Fabrications Evo4 chassis took its place.  Ill make a better build thread later to cover it better but this was a quick run down.  Im going to try and make a meeting in the near future,  Cant make tomorrows since I'm on 2nd shift.  In the mean time my fiance has a 2014 JKU, maybe I can convince her to let me borrow it till the buggy is done, haha.





 

« Last Edit: April 07, 2015, 06:55:04 AM by toreadorranger »

Offline calvynandhobbs

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 3087
Re: Welcome to the JT4x4 Club Forums........
« Reply #297 on: April 07, 2015, 02:07:32 PM »
Welcome to the forum. That is going to be a killer rig.
1994 YJ on 37s

Offline Mayhem

  • BANNED
  • Rock Crawler
  • *****
  • Posts: 336
Re: Welcome to the JT4x4 Club Forums........
« Reply #298 on: April 07, 2015, 05:21:19 PM »
Wow.  Great looking build.  Welcome to the forums.
Greg
Model Citizen

Offline DirtyJeep92

  • Paid Members
  • Rock Crawler
  • ***
  • Posts: 438
  • 96 XJ HP44/9" 37s chopped caged.
Re: Welcome to the JT4x4 Club Forums........
« Reply #299 on: April 10, 2015, 03:06:03 AM »
New to the forum, From Salem.  I have a project that has gotten out of control.  What started as a half ton Solid axle swap for my Ranger, has morphed into a full on buggy build.  Swapped the 1/2 tons for D60/D70 combo, then bought a set of 47" LTBs, so the 1tons got swapped for a set of steering rockwells, then decided I wanted a 4 seater so the frame and cab got scrapped and a Bent Fabrications Evo4 chassis took its place.  Ill make a better build thread later to cover it better but this was a quick run down.  Im going to try and make a meeting in the near future,  Cant make tomorrows since I'm on 2nd shift.  In the mean time my fiance has a 2014 JKU, maybe I can convince her to let me borrow it till the buggy is done, haha.





 


wouldn't still happen to have the Ford front axle kick in around would Yah:-)
ED 2