The Mud Pit > Wrenching

cad gone bad

<< < (3/3)

PaulW:
the housing was from an 84 4cyl and was going into an 89. no prob but motor trans and tcase were from a 94. no vaccum system.  bought a seal for a 94 pulled the carrier out and it turns out that the seal is larger then the boss where you would put the seal in.  the seal had a metal outer layer on it when cut off it became a perfect fit and w

PaulW:
Worked as it should.  mine were  xjs, but it should b the same on urs

Navigation

[0] Message Index

[*] Previous page