The Mud Pit > Wrenching

cad gone bad

(1/3) > >>

gearhead1985B:
today my jeep 4x4 indicator was coming on randomly so i think the cad on my jeep is going bad so i decided to replace it with a axle out me a cherokee is theres any thing else i need to put it in

PaulW:
Inner axle seal.

kirksjeep:
It might be the vacuum switch on the T-case.  It also could be a short in the wires. The fork in the CAD acts as a ground for the elecrical switch.  The most comon failure is the miles of vacuum lines going from the engine to the T-case and then up to the front axle. 

Even better, swap out the shafts for some out of a 96+ XJ or TJ and do away with the CAD and get the bigger U-joints.

BlacXJeep:
he was talking about doing that all weekend

gearhead1985B:
yes i am going to swap out the shafts and seal this saturday and i am getting a brake booster out of a 95 and some 33's :P

Navigation

[0] Message Index

[#] Next page