Author Topic: brake job tomorrow or thurs night  (Read 2810 times)

Offline rocket

  • Trail Master
  • *****
  • Posts: 2802
  • That is what i call, "Flexing"
    • my webshots photo site - lots of wheeling pics!
brake job tomorrow or thurs night
« on: February 25, 2009, 02:05:27 AM »
So, while putting my way home tonight from work in the MPG-mobile, i hear a metalic rattle.  almost like loose change in vibrating in a cubby hole.  So when i get home and investgate (while airing up).  I find that one of the pins that holds my brake pads (passenger side) is haning part-way out (not enought to hit the rim, thank God!)!  It looks like the clip is broke.  I went ahead and ran my finger on the rotor.  It is nice and wavy.  The drivers isn't too bad, but I'm gonna go ahead and replace pads/rotors tomorrow (if i have time) or thurs.  Did not plan on this :(  Luckly, i can probably get my rotors cheaper than pads, so I'm looking at getting it all done for around $100 (thats w/ ceramic pads) !  Not bad comparred the the Passat I did (front pads were $90).

Anyway, if anyone is board tomorrow or thurs after 6pm, come on over!
1973 Chevy El Camino: 383 sb, lots of power
2004 Toyota Tacoma TRD 3.4L xtra cab 2.5" skyjacker coilovers/leafs, 32x11.5-15" Super Swamper TSL/SXs, Bent-up front bumper, smittybilt winch, 4xInovations sliders, Bud-built skids, custom rear bumper/light bar, hella lights, "custom" body work

Offline kirksjeep

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 1267
  • It's hip to be square (headlights) !
Re: brake job tomorrow or thurs night
« Reply #1 on: February 25, 2009, 04:21:47 AM »
I'll be doing ISR's all week (I'm sure you remeber how draining they are).  When I did brakes on my POS Jetta it set me back about $50 for new rotors and pads.  Hopefully your brake job will go better then mine,  the bolts on the passenger side caliper were stripped out by the previose owner.  Luckly they sell caliper bolts at autozone, so I replaced them. 
1992 YJ Sahara, 4.5 Rubicon Express ED Lift, 35" BFG MT, Custom Bumpers, SYE/CV Drive Shaft, OBA, Ford 8.8 rear, 4.10 gears, tie rod flip, 1"MML/BL
2002 KJ Liberty, 2" Lift, 31" tires/DD
2002 F-150 Harley Davidson 5.4L SC
2013 Explorer Sport
2006 Harley Road King Classic
1988 Honda Hawk GT

Offline smaug1911

  • Honorary Member
  • Rock Crawler
  • ***
  • Posts: 473
Re: brake job tomorrow or thurs night
« Reply #2 on: February 25, 2009, 05:05:22 AM »
SHould be easy....I have done tacoma front brakes before.

BUT,,,,,,,,,,,, I have reahearsals every night this week. Guess that doesn't help.

97 V6 Tacoma TRD. 2.5" front coil spacers. 3.5' Downey leaf springs, 2" 4Crawler body Lift, rear Bilstein 5125's, 35" BFG KM2's, Skid row transfer skid, Ocean State Crawlers front winch bumper, custom rear bumper, Kajobuilt sliders, deckplate mod, grey wire mod, Smittybilt XRC8.

Offline CaptORM

  • Rock Crawler
  • ****
  • Posts: 497
    • JT 4X4
Re: brake job tomorrow or thurs night
« Reply #3 on: February 25, 2009, 12:35:24 PM »
I just did my brakes last sat.  I thought something was wrong with the fronts cause I had some grinding.  Took front tires off and found my front brakes in perfect shape.  Replaced the slightly worn rotors anyway.  Took the rears off and holy shit.  There was no brake pad left.  I mean no brake pad.  So replaced those and now everything is great.  Jeep stops on a dime.  Cost me about $90 for all.  Had a few parts still under warrenty though.
I do cheeks for free just ask...
 
 l  
 l _[==]__o___o
 l//_|__l__l,\___\,___
 l_--\__\__l_/---\_[] llll [)
  (o)_)        (o)_)--o)_)



96 Jeep Grand Cherokee
6.5" lift, 33's

PaulW

  • Guest
Re: brake job tomorrow or thurs night
« Reply #4 on: February 25, 2009, 01:24:59 PM »
ugh i dont want to look at onother vehicle for at least a week, i had to replace both frot wheel bearings on my wifes windstar last night, and needless to say i'm highly hungover!

Offline HOT-ROD

  • Trail Master
  • *****
  • Posts: 2190
Re: brake job tomorrow or thurs night
« Reply #5 on: February 26, 2009, 03:00:04 AM »
i am hoping the beer helped you out.

Offline HOT-ROD

  • Trail Master
  • *****
  • Posts: 2190
Re: brake job tomorrow or thurs night
« Reply #6 on: February 26, 2009, 03:03:02 AM »
jeremy,

it should only take 12 min per side to swap everything for new hard ware.

have a good wratchet 3/4 is best with an extension. and vise grip pliers for taking the pins out of the caliper (p i t a)

Offline rocket

  • Trail Master
  • *****
  • Posts: 2802
  • That is what i call, "Flexing"
    • my webshots photo site - lots of wheeling pics!
Re: brake job tomorrow or thurs night
« Reply #7 on: February 26, 2009, 04:54:05 AM »
Guess nobody really read my first post: MPG-mobile is NOT a tacoma, its the aspire.  I know how easy tacoma pads are; you can leave the calipers in (right justin and garry, remember that before breakneck?).  And pads themselfs were not cheap.  Anyway, its after 10:30 and I just got home (had late/unplanned meetings at work then Bible study).  Hopefuly I can get out of my meeting early enought to hit napa before they close tomorrow and get started!)
1973 Chevy El Camino: 383 sb, lots of power
2004 Toyota Tacoma TRD 3.4L xtra cab 2.5" skyjacker coilovers/leafs, 32x11.5-15" Super Swamper TSL/SXs, Bent-up front bumper, smittybilt winch, 4xInovations sliders, Bud-built skids, custom rear bumper/light bar, hella lights, "custom" body work

Offline calvynandhobbs

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 3087
Re: brake job tomorrow or thurs night
« Reply #8 on: February 26, 2009, 01:36:35 PM »
I would offer to help, but I have to coach basketball tonight. The end of the season tournament runs tonight through Saturday.
1994 YJ on 37s

Offline rocket

  • Trail Master
  • *****
  • Posts: 2802
  • That is what i call, "Flexing"
    • my webshots photo site - lots of wheeling pics!
Re: brake job tomorrow or thurs night
« Reply #9 on: February 27, 2009, 12:25:05 AM »
So, i went to napa and they don't have my rotors or caliper hardware instock.  I'll get it tomorrow and go from there.  "premium" rotors are only $18!!  my total w/ ceramic pads, 2 rotors, caliper hardware was about a hundred bucks!
1973 Chevy El Camino: 383 sb, lots of power
2004 Toyota Tacoma TRD 3.4L xtra cab 2.5" skyjacker coilovers/leafs, 32x11.5-15" Super Swamper TSL/SXs, Bent-up front bumper, smittybilt winch, 4xInovations sliders, Bud-built skids, custom rear bumper/light bar, hella lights, "custom" body work

Offline kirksjeep

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 1267
  • It's hip to be square (headlights) !
Re: brake job tomorrow or thurs night
« Reply #10 on: February 27, 2009, 01:37:18 AM »
Sounds like you just doubled the value of your Aspire!! ;D
1992 YJ Sahara, 4.5 Rubicon Express ED Lift, 35" BFG MT, Custom Bumpers, SYE/CV Drive Shaft, OBA, Ford 8.8 rear, 4.10 gears, tie rod flip, 1"MML/BL
2002 KJ Liberty, 2" Lift, 31" tires/DD
2002 F-150 Harley Davidson 5.4L SC
2013 Explorer Sport
2006 Harley Road King Classic
1988 Honda Hawk GT

PaulW

  • Guest
Re: brake job tomorrow or thurs night
« Reply #11 on: February 27, 2009, 02:38:35 AM »
i am hoping the beer helped you out.

it really did.  i did a count this morning, and realized i had 4 left in the thirty pack.  thank god im smarter then to try to test drive it after the repair.

Offline rocket

  • Trail Master
  • *****
  • Posts: 2802
  • That is what i call, "Flexing"
    • my webshots photo site - lots of wheeling pics!
Re: brake job tomorrow or thurs night
« Reply #12 on: February 27, 2009, 03:19:36 AM »
Sounds like you just doubled the value of your Aspire!! ;D

LOL, probably! 

Since it provides more value to me that what KBB say's it's worth, I wonder if it's possible to insure it for MPG value vice $$$ value.  Each time i drive it vice bambi (my tacoma for you new folk) it is like making me money.  it paid for itself in 5-6 months just in gas savings.  I know there is no way to get a 40+mpg car for the grand it's worth (or whatever I would get after my deductable).
1973 Chevy El Camino: 383 sb, lots of power
2004 Toyota Tacoma TRD 3.4L xtra cab 2.5" skyjacker coilovers/leafs, 32x11.5-15" Super Swamper TSL/SXs, Bent-up front bumper, smittybilt winch, 4xInovations sliders, Bud-built skids, custom rear bumper/light bar, hella lights, "custom" body work

PaulW

  • Guest
Re: brake job tomorrow or thurs night
« Reply #13 on: February 27, 2009, 01:05:04 PM »
Sounds like you just doubled the value of your Aspire!! ;D

LOL, probably! 

Since it provides more value to me that what KBB say's it's worth, I wonder if it's possible to insure it for MPG value vice $$$ value.  Each time i drive it vice bambi (my tacoma for you new folk) it is like making me money.  it paid for itself in 5-6 months just in gas savings.  I know there is no way to get a 40+mpg car for the grand it's worth (or whatever I would get after my deductable).

i bought a 1989 pontiac lemans that got 42 mpg for $900 and that was like 7 years ago.  i miss it, but there's now way it's hold the family now!

Offline rocket

  • Trail Master
  • *****
  • Posts: 2802
  • That is what i call, "Flexing"
    • my webshots photo site - lots of wheeling pics!
Re: brake job tomorrow or thurs night
« Reply #14 on: February 28, 2009, 12:21:43 AM »
starting in a few mintues.  I'll probably be done before anyone could make it up here.
1973 Chevy El Camino: 383 sb, lots of power
2004 Toyota Tacoma TRD 3.4L xtra cab 2.5" skyjacker coilovers/leafs, 32x11.5-15" Super Swamper TSL/SXs, Bent-up front bumper, smittybilt winch, 4xInovations sliders, Bud-built skids, custom rear bumper/light bar, hella lights, "custom" body work