« previous next »
Pages: [1]   Go Down

Author Topic: 36's on 4"  (Read 1479 times)

Offline BayouGold

  • Rock Crawler
  • ****
  • Posts: 442
36's on 4"
« on: February 14, 2009, 05:22:18 AM »
I saw some guys on another forum running 4" short arm lifts w/ 1" bl & 36" iroks on their tj's. guys in washington. a couple had tube fenders but the others had stock.
opinions.... ::)
« Last Edit: February 14, 2009, 05:25:14 AM by BayouGold »
Logged
'01 TJ 60th Anniversary Edition

Offline Axle

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 2008
  • Merica!!!
Re: 36's on 4"
« Reply #1 on: February 14, 2009, 05:28:50 AM »
With the right bump stops and wheel back spacing, sure.  I recommend 3.75" backspacing if you use a 15X10 rim.  However, I would highly recommend putting chromoly shafts in the dana 30 if you plan on putting that Aussie in it and 36's.
Logged
Axle:  2
Nemesis: 1

I win!

Offline HOT-ROD

  • Trail Master
  • *****
  • Posts: 2190
Re: 36's on 4"
« Reply #2 on: February 15, 2009, 03:15:49 PM »
def beef the shafts. iroks have a lot of traction/grip. often, too much (traction) for axles of the housings if you're running stock.

Logged

Offline BayouGold

  • Rock Crawler
  • ****
  • Posts: 442
Re: 36's on 4"
« Reply #3 on: February 15, 2009, 05:06:04 PM »
I'm good in the back, but stock in the front still.
Logged
'01 TJ 60th Anniversary Edition

Offline footman

  • Honorary Member
  • Trail Master
  • ***
  • Posts: 637
Re: 36's on 4"
« Reply #4 on: February 16, 2009, 03:09:32 AM »
I'd say spend some loot on some TnT front and rear tubes, some alloys and go with the 36's!!!!!!!  Yeah baby!!!!
Logged

Offline Doball

  • Honorary Member
  • Rock Crawler
  • ***
  • Posts: 353
Re: 36's on 4"
« Reply #5 on: February 23, 2009, 05:13:03 PM »
I'm pretty sure that the stock D30 is good up to 37's, but I would definately upgrade the shafts before trying bigger than 33's.
Logged
Pages: [1]   Go Up
« previous next »