JT4x4
The Mud Pit => Wrenching => Topic started by: Gr33NGoph3R on August 30, 2011, 05:24:14 PM
-
I have a leaking axle seal I assume its from Mohawk I don't have the tools required to get into it and do it myself and I've never opened and axle before so any assistance would be greatly appreciated
-
I believe the Rubicon 44 front has an internal axle seal that requires removal of the air locker and ring gear to replace. I'll research it to be sure, but I am almost positive that is what your looking at to replace the seal.
-
you might want to try these
http://www.amazon.com/GRANDE-WRANGLER-RUBICON-CHEROKEE-UPGRADED/dp/B003OACOWA
yes they cost 10 times what a normal seal cost but are 10 times easier to install
-
you might want to try these
http://www.amazon.com/GRANDE-WRANGLER-RUBICON-CHEROKEE-UPGRADED/dp/B003OACOWA
yes they cost 10 times what a normal seal cost but are 10 times easier to install
X2
This is a good price, they normally run $65 to $75.
-
Thoes axel seals are only for keeping the dirt out of the axet tubes & are not disigned to hold gear oil in the diff. You do need to replace the axel seals & you will need to remove the compleat carrier asembly w/air locker. I also recomend buying a seal installer witch is a threaded style spreader witch has a seal cup on each end & makes installing both seals at the same time a snap. I do not own one but when the time comes when mine start leaking I will buy one. I assume it can't be too expensive. Im shure there's other ways to install the seals but if not installed compleatly straight & they will start leaking again & it sucks when you have to do it all over again. Do it right the 1st time.
The outter seals are not a bad idea cuz they can keep the dirt away fron the internal seals witch can leed to seal failure. Not shure on how well they work tho.
-
I thought that is what those type of seals were for, but I didn't know for sure. Good info Bob. I agree with him though. The seals are a pain to install. I did mine of my HP60 without the tool. It just took a lot of time.
-
Kirk has these on his axle and I think they do keep the oil from leaking.
-
i got a set used from the jy and they kept all my fluid inside my diff but i pumped them full of grease once a month
-
I put a set in my 92 YJ and they do keep the gear oil in, the biggest thing to remember is to keep them full of grease. I had a slow leak out of the axle tube and once I installed them the leak stopped. I didn't want to go through the trouble of replacing the inner seals so I got these. If you are still running stock shafts in a YJ with the vaccum disconnect and you want a set of these, a CT company called Seal-it sells them. I took apart my axle and gave them the dimensions so they could make a set that would work with the larger shafts. Seal-it was the company that first developed these style of seals. Here is the website if anyone decides that they want to get a set for a YJ. http://www.sealsit.com/
Brian
-
Just because the leak stopped does NOT mean the leak is fixed. It will just start filling up the axel tube & the fluid level will get low in the diff. As I said before. These seals are only made to keep the mud, dirt & debris out of the axel tube to protect the inner axel seals.