JT4x4

The Mud Pit => General => Topic started by: Flex on March 17, 2010, 05:03:49 AM

Title: NP 241bolt
Post by: Flex on March 17, 2010, 05:03:49 AM

anyone know if a Np241 out of a Rubicon will bolt into a XJ, i know it has 4:1 and a fixed yoke, right?

Title: Re: NP 241bolt
Post by: BlacXJeep on March 17, 2010, 02:47:06 PM

I have heard of this before think its been done

Title: Re: NP 241bolt
Post by: calvynandhobbs on March 17, 2010, 03:12:30 PM

I just went over to NAXJA and tried looking around. I found several threads where people swapped in a 241 from a Rubicon with AX15 transmissions to XJs with AX15s, but I couldn't find anything about the automatic. It looks like it is a complete bolt in for manuals, but not too sure on putting one behind a AW4.

Title: Re: NP 241bolt
Post by: Flex on March 17, 2010, 06:37:13 PM

well the the np 231 is the exact same between automatics and manual so i would assume that it would swap right over.

So am i correct to believe that has the 4:1 low and a fixed output

Title: Re: NP 241bolt
Post by: calvynandhobbs on March 17, 2010, 08:25:34 PM

Quote from: Flex on March 17, 2010, 06:37:13 PM

well the the np 231 is the exact same between automatics and manual so i would assume that it would swap right over.

So am i correct to believe that has the 4:1 low and a fixed output

As far as I can tell you are correct in that it has the 4:1 and a fixed output. I have added a link to a small write up on NAXJA. Everything appears to be bolt in except switching out yokes.

http://www.naxja.org/forum/showthread.php?t=941891&highlight=nv241 (http://www.naxja.org/forum/showthread.php?t=941891&highlight=nv241)

Title: Re: NP 241bolt
Post by: gearhead1985B on March 17, 2010, 10:14:59 PM

it is a direct bolt in unless clocking is differnt i spent some time on novak and that is what i concluded they both have a 6 bolt patern and a 23 spline input