JT4x4

The Mud Pit => General => Topic started by: BayouGold on February 14, 2009, 05:22:18 AM

Title: 36's on 4"
Post by: BayouGold on February 14, 2009, 05:22:18 AM

I saw some guys on another forum running 4" short arm lifts w/ 1" bl & 36" iroks on their tj's. guys in washington. a couple had tube fenders but the others had stock.
opinions.... ::)

Title: Re: 36's on 4"
Post by: Axle on February 14, 2009, 05:28:50 AM

With the right bump stops and wheel back spacing, sure.  I recommend 3.75" backspacing if you use a 15X10 rim.  However, I would highly recommend putting chromoly shafts in the dana 30 if you plan on putting that Aussie in it and 36's.

Title: Re: 36's on 4"
Post by: HOT-ROD on February 15, 2009, 03:15:49 PM

def beef the shafts. iroks have a lot of traction/grip. often, too much (traction) for axles of the housings if you're running stock.

Title: Re: 36's on 4"
Post by: BayouGold on February 15, 2009, 05:06:04 PM

I'm good in the back, but stock in the front still.

Title: Re: 36's on 4"
Post by: footman on February 16, 2009, 03:09:32 AM

I'd say spend some loot on some TnT front and rear tubes, some alloys and go with the 36's!!!!!!!  Yeah baby!!!!

Title: Re: 36's on 4"
Post by: Doball on February 23, 2009, 05:13:03 PM

I'm pretty sure that the stock D30 is good up to 37's, but I would definately upgrade the shafts before trying bigger than 33's.