JT4x4

The Mud Pit => Wrenching => Topic started by: B52BUFF on April 21, 2015, 04:29:27 AM

Title: Propane
Post by: B52BUFF on April 21, 2015, 04:29:27 AM

Has anyone looked into converting over to propane? How hard would it be and how expensive? Are there any benefits or drawbacks?

Title: Re: Propane
Post by: toreadorranger on April 21, 2015, 11:15:56 AM

On what motor?  If you already have EFI than its not worth it but if you are running a carb, than it could be benefitial depending on the setup.  Propane setups don't get starved for fuel when running at excessive angles like a carb can. 

Title: Re: Propane
Post by: calvynandhobbs on April 21, 2015, 12:36:53 PM

Hey Chuck, exactly what was said above. Propane allows carb rigs to run at angles like if you have EFI.

Title: Re: Propane
Post by: Mr Rock on April 22, 2015, 01:31:20 AM

Check out http://gotpropane.com/ for info and pricing, but like everyone else said it's to convert carbed motors.

Title: Re: Propane
Post by: B52BUFF on May 04, 2015, 09:08:43 PM

Thank you for the input.