The Mud Pit > General
My new(ish) gas saver!
CnoteTJ:
--- Quote from: Axle on July 01, 2008, 04:50:33 PM ---I was planning on doing it tonight, if you guys are free. I could use some alignment training. That's an average savings of $70+!!!
--- End quote ---
Now this seems like a shade tree method that everyone should know! Give a call if ya need a hand Axle. 8)
reg:
--- Quote from: Seabee_BUC on July 01, 2008, 04:31:57 PM ---
--- Quote from: reg on July 01, 2008, 04:04:00 PM ---I'd really like to see this done... if you don't mind, give me a call when you get ready to start.
--- End quote ---
Are you referring to the alignment Reg? Does yours need one too??? If you PB blast the snot out of the adjusting sleeve (if you have one??) we can do them both in a very short time. If you have your stock setup, we can still do it, just need to make sure all the threaded parts are free to turn. Only takes about 10 minutes to do it 100%.
--- End quote ---
nope, alignment done already, I got that covered. I measured whell lip to wheel lip (min. tire bulge) I just wanted to see the steering swap. My tierod is protected a little more by the leaf springs, but i havebounced on it a few times. I would like to upgrade as well. I do have an extra one though (stock) I'd rather just not have to use it.
Axle:
Depending on when/if Scott is available is when it will happen. I'll post a time and anyone who wants to see or help is welcome to come.
Steve!!!! We could start a JT4X4 Motorcycle branch!!! ;D
reg:
--- Quote from: Axle on July 01, 2008, 06:38:55 PM ---Depending on when/if Scott is available is when it will happen. I'll post a time and anyone who wants to see or help is welcome to come.
Steve!!!! We could start a JT4X4 Motorcycle branch!!! ;D
--- End quote ---
that would be jt2x1
Navigation
[0] Message Index
[*] Previous page
Go to full version