Ok so It's all done and we had some rather unorthodox methods to fixing the sheared bolt problems. Worked wonders though and got the job done. I'll post up pictures tomorrow when It's daylight.
The bolts were stuck in the nuts really good. Despite all the PB Blaster and the huge drill holes for the easy out, it wasnt happening. I wound up hammering a center punch through them and breaking the welded nuts off the back. They were easily accessed through a hole in the shock mount plate. Getting new nuts on the back is NOT easy to do by hand. So be creative. Use a 3/8 inch nut and bolt with a washer on the bolt. Take a 1/2 inch box/open end wrench. Put some Nuke Red tape on the box side so that the wrench angles up when the nut is flat. Stick the nut in the box and to the tape. you can use this in the plate hole to get to where the bolts come through. Once you get the screw to engage 2 or 3 threads break the wrench off and turn it around to the open end. If you dont, you'll tighten the bolt and the wrench will be stuck. Tighten em up and move on to the next one. Works great! Hope that helps anyone who needs this in the future.