The Mud Pit > Wrenching
throwing in the flag!
reg:
--- Quote from: Doball on February 21, 2008, 12:37:36 PM ---Good Luck! For $340 from Advanced, I'd start looking into an entire axle upgrade!! ;D
--- End quote ---
I know!!! >:( about the cost of an old 44
albsvx:
which, as far as I know, usually still use unit bearings. :)
HOT-ROD:
wow, that sucks, rich had to do the same thing on the dodge. wasn't as expensive if i recall correctly.
we can do the swap out at the AZ parking lot. how cool would that be? LOL!!
Doball:
--- Quote from: albsvx on February 21, 2008, 04:58:47 PM ---which, as far as I know, usually still use unit bearings. :)
--- End quote ---
Depends, my okd CJ had a '77 scout D44's, I replaced the bearings on it.
One-Eye:
I am sure you know already but the hub nut is a 36mm. If you need the socket let me know, I have it. When we did Capt's, and Cheeks (I think it was cheeks) it made it a lot easier to leave the bolts on the inside of the hub unit (behind the break calipers is) in a little bit and hit the back of them. You may want to get some new hardware before because we pretty much killed Capt's when doing it but it came out pretty easy after that. If you need a hand just let me know. It really isn't that hard to do. Like Al said, when you go to put it back in anti-sieze the hell out of it and it comes out a lot easier then.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version