The Mud Pit > General
'78 Jeep J10
Big Chuck:
What carb is on it? If it is the motorcraft 2100/2150 it is Wicked easy. The rebuild kits are readily available and instructions can be found online, YouTube or print them out and follow along. That is the V8 correct?
Chuck
JSchwinn:
Yes it s the AMC 360 and I believe that's what it has for a carb but ill have to check. L'll look into the kit I was looking to take the lazy way out and pay someone to do it because ive never messed with a carb before.... guess now is as good a time as ever.
JSchwinn:
Also, I need to get 2 straight 2.5" exhaust pipes bent about 5 degrees, anyone know a place I can get it done cheap?
Big Chuck:
Did I hear that Tim and Tom have a Pipe bender?
JSchwinn:
Help...... this past weekend I replaced the intake/carb with an edelbrock. The engine fired right up and there seemed to be no issues even when it got up to temp. When I went to take it for a ride about 5 minutes in the oil pressure drops down slowly to 0. There doesn't seem to be any noticeable changes in noise. I replaced the sending unit along with a full oil change with rotella 15w40. It almost seems like the oil isn't getting back into the pan. When I got home I turned the engine off waited 15 minutes and turned it back on and had 40psi. I really have no clue where to go from here and could you any advice you can give.
The Engine is an AMC 360 stock other than the edelbrock upgrades. Also eliminated all the emissions crap so I only have vacuum to brake booster/PCV/Dizzy
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version