The Mud Pit > Wrenching
New winter beater.....possible new wheeler as well
toreadorranger:
All the misc parts all cleaned up.
Since the Ford knuckles are known to break or crack at the upper kingpins, I bought a set of rydel fab gussets to add to them.
Rydels photos but hopefully mine should come out just as nice.
toreadorranger:
Had to get the truck towed home from Mass this week. I was going to pick up a rear axle and the water pump seize up on me then lost the front shaft seal and dumped all my coolant. New water pump is on its way going to start looking into a set of electric fans for it as well.
skibum:
1big Flex a Light 180. Those suckers move some air. Or an old Ford Taurus fan.
toreadorranger:
yea, I was eyeing up the Taurus fans, apparently some mid 90's Volvos had the same fans as the Taurus and are prewired with a relay, making them even easier to swap.
toreadorranger:
Finally got the truck all back together. 35 Spline stub shafts are in the mail, and I think I found a free set of 4.10 gears for the D60, so once I get those I can start putting it all back together.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version