The Mud Pit > Wrenching
Bent Fab EVO 4 Build "RangeKrawler"
Big Chuck:
You are going to have it all buttoned up and ready to go wheelin Saturday morning right? HAHA, looks good man!!!
Chuck
toreadorranger:
I wish it was ready. Ordered a set of Rockwell Flange outputs for the NP205. Allows me to run the factory M35 6x6 trucks driveshafts. Ill have to lengthen or or shorten the actual driveshafts as needed but they will bolt to the tcase just fine. I have a few of them that came with my axles when I bought them and flanges are just so much easier to work with since you don't have to worry about U joint caps staying on when your messing with them as well as keeping spares on the rig or trailer.
toreadorranger:
Ive been working on getting the NP205 all finished up. I just need the new flanges to show up so I can figure out what size seals I need to install in the seal housings, than I can get it all finished.
Diy4x PTO cover and 32 spline front and rear outputs. installed some adjustable shift detents as well.
toreadorranger:
finally got the Tcase all buttoned up. Flanges are on, they are big. but the 2.5ton driveshafts are cheap so its worth it. Next I can move on to getting the motor and trans in the buggy and mocking them up with the front suspension
Navigation
[0] Message Index
[*] Previous page
Go to full version