The Mud Pit > Wrenching

99 Explorer 8.8 rear

(1/4) > >>

Big Chuck:
Well Alright, I finally picked up my new rear diff from a 99 Explorer, 4.10 open. I have a 4.10 dana 30 almost ready for install. I am getting ready to order Calipers and Swap kit from ECGS along with a 1330 flange adapter. Now if the weather would get better and my garage would get bigger we would be all set LOL.
Chuck

Mr Rock:
Did you weld the tubes to the center section yet? if you are ordering from ECGS you should pick up a spartan locker from them too!

Big Chuck:
I haven't done a thing to it yet.

JSchwinn:
You should make your garage big enough so we can fit my jeep and do it at the same time lol

Mreecew:
Good job, make sure you weld the tubes, get a locker and a SOLID dif cover, then all you need is to attend a "drive like rock" training session. Also before you put the 30 in make up some C gussets like rocks yj and my fathers yj have, also 97+ shafts would be worth putting in so you don't have to worry as much.

Navigation

[0] Message Index

[#] Next page