The Mud Pit > Wrenching

Stop and Go Transmission--- Great service!!

<< < (3/3)

JKJon:
Wish I had known all of these break in procedures before I had the second set of gears installed and did a road trip up to NH and back a couple days after install. I did about 80mph there and back. Around 600 miles. Really not feeling good about the strength of my setup now.

Harryhood:

--- Quote from: JKJon on February 18, 2014, 04:30:17 PM ---Wish I had known all of these break in procedures before I had the second set of gears installed and did a road trip up to NH and back a couple days after install. I did about 80mph there and back. Around 600 miles. Really not feeling good about the strength of my setup now.

--- End quote ---

best thing you can do now is change the fluid. when gears break in filings are created, best to get them out and put new fluid in.

Bill3753:
Pull the diff cover and drain it completely.  Get a LOT of brake cleaner (spray cans) and spray it all out making sure all the oil is 100% cleaned out.  It'll take a good 5-6 cans.  Check for a magnet (some diffs habe one, some do not) and clean it off to remove all the shavings.

Reinstall the cover and fill with a good synthetic gear lube.

Navigation

[0] Message Index

[*] Previous page