The Mud Pit > Wrenching
Jeep Cherokee Build
Carfreek458:
So i decided to swap my axles out so i could have 3.55s instead of 3.07s and also go my hands on some other parts like skid plates hd cross member rear bumper and some other things. figure i make this thread so people could see the work im doing. I have almost finished the rear and ill be moving onto the front soon and skid plates and few other things. more pics soon
Old rear axle with 3.07s
tomken engine/tranny skid
Rear axle with 3.55s back in and repainted the rear bumper
Messing around with paint
Before the axles out
Axle is out
New axle for the jeep
Tomken engine/tranny skid on
Swapped my hatch to my black one
No more bent tie rods
New 8.25 yoke
Front diff cleaned and locker installed
HD diff back on with new lube locker
Custom HD cross member i made and tranny skid mounted to it
Axle back in new tie rod and ends
skibum:
I like the rear bumper. Beefy ;D
Carfreek458:
Thanks i like it alot just wish it came with the tire carrier.
calvynandhobbs:
--- Quote from: Carfreek458 on March 06, 2013, 11:24:09 PM ---Thanks i like it alot just wish it came with the tire carrier.
--- End quote ---
I like that rear bumper too. All you need is some 2x2 square tubing and with a little cutting and welding you could build a swing-out. Looks like it was set up with a swing-out at one time. Scott and I built this bumper for my XJ and it turned out really good.
Carfreek458:
Yes it had one at one point guy said someone stole it or something and its made by Rock Hard. But when i have some money ill buy some metal but will need help making it.
Navigation
[0] Message Index
[#] Next page
Go to full version