The Mud Pit > Wrenching
Vibration when I hit the gas pedal...
kirksjeep:
Overland wants somewhere around $50 to ballance a driveshaft. I asked about it a few years back.
Also check your skid plate. If it is bent in the right spot it will push the driveshaft to one side. Also check the rear control arm mounts.
Coqui:
Any recommend on ujoints?
gearhead1985B:
--- Quote from: Coqui on October 02, 2012, 04:09:43 AM ---Any recommend on ujoints?
--- End quote ---
cheap and not greasable (i normally smash the grease fitting till it is not usable) and remeber where you bought it so you can warrenty it later
calvynandhobbs:
--- Quote from: Coqui on October 02, 2012, 04:09:43 AM ---Any recommend on ujoints?
--- End quote ---
I have at least one driveshaft ujoint and axle shaft ujoint left over from my 98 TJ if you want them. I've used the Autozone Duralast Gold joints that are non-greasable and never had a problem with them. A lot of them have warranties so I'd buy a new one at whatever store you normally pick up parts for your Jeep. Makes it easier to remember where they came from.
skibum:
Get under there & start moving u joints around till you fine a sloppy one. You will no when you find the bad one. If its causing a vibration on acell then its pritty sloppy.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version