*Starts off with a big sigh*
So, got the T-Case done...ish. Everything is together, finally!!! took it out of the driveway and started going up the road. Then it happened. Sounded like one of the gears slipped out of place. So after a very thorough recollection of the events leading up today I started going through the directions again. To me it sounded like I said, the gears slipped out of place. And what might you ask holds the gears in place normally? A snap ring. Well, after going through the directions I noticed that no where in them did it say anything about placing a snap ring back in. I was very miticulous with following the directions. So much so that I think I forgot to use common sense. Sure enough, the infamous snap ring is sitting on my oil catch can where I put it. GREAT!!! Now I get to take it all apart again and figure out where the damn ring is supposed to go. Ed...I blame you! 4 wheel drive worked great, just the whole gears moving around thing. Story of my life. But hey, I moved it so that is good...right?