« previous next »
Pages: [1]   Go Down

Author Topic: Transmission mount  (Read 1258 times)

Offline B52BUFF

  • Rock Crawler
  • ****
  • Posts: 397
Transmission mount
« on: September 22, 2011, 11:25:11 PM »
Got the mount in finally.  No more rattling but the TJ seems to vibrate more that I remember it doing before I broke the mount.  Is there some sort of adjustment that needs to be made?  It isn't the factory mount. It is an aftermarket mount polyurathane. Any ideas?
Logged

Offline skibum

  • Paid Members
  • Trail Master
  • ***
  • Posts: 869
Re: Transmission mount
« Reply #1 on: September 23, 2011, 12:12:28 AM »
Polly mounts & bushings are less forgiving than rubber so you will notice a slight bit more vibration or road feed back when used on suspention parts. Not shure how bad of a vibration your getting so not shure if its nornal or not. If your comming to the next trail ride I would like to feel this vibration your talking about.
« Last Edit: September 23, 2011, 01:23:04 AM by skibum »
Logged
09 Rubi 4Dr,Compleat Heavy Duty Polly Performance skid plate system,Kilby Evap Relocation kit,Rampage front bumper,Swaybar motor flip,Clayton 3.5in lift w/steering corection kit,35in GY MTR's on 15in MB Wheels,Ace Enginering Rear Bumper W/Tire carrier,Prorock D44 Front axel,5.13s,cromo rear shafts

Offline B52BUFF

  • Rock Crawler
  • ****
  • Posts: 397
Re: Transmission mount
« Reply #2 on: September 24, 2011, 05:15:45 PM »
That would make sense.  I really only notice it when I am idling.  Otherwise everything seems fine
Logged
Pages: [1]   Go Up
« previous next »