The Mud Pit > Wrenching
Lift
Gr33NGoph3R:
3" so improbably looking at another grand in parts? roughly
Bill3753:
3" would make it borderline if you'd need one or not. If it were me I would do it if you can afford it.
For the SYE and CV conversion you'll need the following parts:
Slip Yoke Eliminator Kit for NP231
CV Drive Shaft
Adjustable Rear Upper Control Arms to set the pinion angle
Adjustable rear track bar with a hemi joint on the axle side to avoid binding due to the pinion being turned up
Other then that you'll need all the other lift parts you were looking to get. What kit you looking at getting?
Gr33NGoph3R:
--- Quote from: Bill3753 on March 12, 2011, 12:10:22 AM ---3" would make it borderline if you'd need one or not. If it were me I would do it if you can afford it.
For the SYE and CV conversion you'll need the following parts:
Slip Yoke Eliminator Kit for NP231
CV Drive Shaft
Adjustable Rear Upper Control Arms to set the pinion angle
Adjustable rear track bar with a hemi joint on the axle side to avoid binding due to the pinion being turned up
Other then that you'll need all the other lift parts you were looking to get. What kit you looking at getting?
--- End quote ---
ok just to make sure my mind is officially in the right place I want to get a 4" skyjacker full suspension lift this costs only a little more than the 3" i was looking at and is much better if i get that installed and do the drop my issue is still getting hung up on obstacles but if I do it anyway and get the other parts you've mentioned over time I can get rid of that drop once I have all of them anyway it would just be easyer for me this way so I dont have to drop an extra grand right now but get it where I have the money over time
skibum:
Synce it's a Rubicon it already has the slip yoke in the drive shaft & a shortened tail shaft housing on the T case so you should be ok with a 3in lift. Also you have the NP241 T case. Worst case you might need to replace your rear drive shaft with a slightly longer one.
Gr33NGoph3R:
K that makes things a little cheaper thx
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version