The Mud Pit > Wrenching
AX-15 issues
Mr Rock:
I'm looking for some input.
My tranny has been acting up for a while now, and it's hard to shift, grinding in every gear and now it gets stuck in gear and it's getting worse. It started making noise like a bearing is going when it's in neutral and I let the clutch out?
Do I attempt to rebuild it (it has over 170K on it) look for a used one, (around $450) for a direct replacement. or go for a external slave setup (used $750) or ??
Thoughts?
skibum:
Call me. I might be able to stop over & look at it for you if you want.
Mr Rock:
--- Quote from: skibum on January 20, 2011, 12:01:37 AM ---Call me. I might be able to stop over & look at it for you if you want.
--- End quote ---
What are you doing Saturday?. I'm sure I can talk my neighbor into using his lift in his heated garage!
Will, this might be a good time to do your u-joints!
calvynandhobbs:
Sounds like your tranny is going to need some work. I had problems with mine popping out of 2nd gear and difficulty shifting when it was cold last winter and switched to a synthetic fluid. It almost completely went away within a week and I really haven't thought about it since.
skibum:
--- Quote from: Mr Rock on January 20, 2011, 12:39:52 AM ---
--- Quote from: skibum on January 20, 2011, 12:01:37 AM ---Call me. I might be able to stop over & look at it for you if you want.
--- End quote ---
What are you doing Saturday?. I'm sure I can talk my neighbor into using his lift in his heated garage!
Will, this might be a good time to do your u-joints!
--- End quote ---
Im free on Saturday. What time?
Sounds like your slave cyl is leaking causing hard shifting & sticking into gear. Check fluid in Clutch master cyl resiviour. If it's low then it's leaking. Noise when you let clutch out could be the input bearing going bad. Will need to hear it. Also if you don't use the correct fluid for the AX15 then it will give you issues.
Navigation
[0] Message Index
[#] Next page
Go to full version