The Mud Pit > General
Welcome to the JT4x4 Club Forums........
98xj:
--- Quote from: calvynandhobbs on April 24, 2014, 05:19:55 PM ---Hey Jim,
I'm in over my head with house projects right now and haven't even had a chance to work on my Jeep in way too long, but there may be others here that could give you a hand. Have you come across Stu's page of Jeep repairs yet? Here is the link to ujoint replacement. I would suggest going to home on his page and bookmarking it. There are a lot of good write ups on his website.
http://www.stu-offroad.com/axle/ujoint1/u-joint-1.htm
--- End quote ---
I was going to suggest a similar method, balljoint press is definitely the way to go. I spend 150 bucks on a press at harbor freight the first time I did mine. It worked but it's super excessive.
Mreecew:
--- Quote from: 98xj on June 24, 2014, 08:36:52 PM ---Another new member! ;D Hey JT, my names Jacob. I'm from New Britain and drive an XJ. I work as a line cook in West Hartford and have slowly been getting into the 4wheel community. I have a 4.5 inch BDS short arm lift and 33's. Most recently I installed the Detours Tailbone rear tire carrier (which is an amazing system). 4.0 I6, sye and cv driveshaft, stock 29 spline 8 1/4 rear, d30 front, and a bunch of stickers haha. Look forward to participating and meeting up! ::)
--- End quote ---
Welcome welcome. I noticed you didn't post what your rig was... I'm forced to assume your part of the unibody crowd also? ;D ;D ;D ;D
skibum:
Nice 98 XJ. Welcome to the forum
98xj:
--- Quote from: Mreecew on June 25, 2014, 05:34:22 AM ---
--- Quote from: 98xj on June 24, 2014, 08:36:52 PM ---Another new member! ;D Hey JT, my names Jacob. I'm from New Britain and drive an XJ. I work as a line cook in West Hartford and have slowly been getting into the 4wheel community. I have a 4.5 inch BDS short arm lift and 33's. Most recently I installed the Detours Tailbone rear tire carrier (which is an amazing system). 4.0 I6, sye and cv driveshaft, stock 29 spline 8 1/4 rear, d30 front, and a bunch of stickers haha. Look forward to participating and meeting up! ::)
--- End quote ---
Welcome welcome. I noticed you didn't post what your rig was... I'm forced to assume your part of the unibody crowd also? ;D ;D ;D ;D
--- End quote ---
I am a unibody...er? lol I have a 98 Jeep Cherokee Classic. I'm still trying to figure out this forum I'll try to get my info up.
98xj:
--- Quote from: skibum on June 25, 2014, 01:02:54 PM ---Nice 98 XJ. Welcome to the forum
--- End quote ---
Thanks ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version