The Mud Pit > Wrenching
Comanche
Flex:
Dosent look like i will have an issues with the current rim backspacing but ill take another look.
As for as u-joints i was pretty sure these are 1410 but if there 1350 then ill just use a conversion u joint however ill still need to make a rear drive shaft probably out of some DOM due to the one that came installed is trash.
Bill3753:
What diameter is the tube of the drive shaft?
You might be able to get by cheaper by using something around 1/2" or bigger wall regular non-DOM tube. I'm sure if you went with something that heavy it would hold up fine and you'd still be cheaper then DOM.
Flex:
So the Comanche project is nearly complete just waiting a few parts to come it. ill have pics next week hopefully while its driving down the road.
Mr Rock:
--- Quote from: Flex on March 29, 2011, 03:08:11 AM ---So the Comanche project is nearly complete just waiting a few parts to come it. ill have pics next week hopefully while its driving down the road.
--- End quote ---
Sounds like a Trail Ride is needed!
Bill3753:
--- Quote from: Flex on March 29, 2011, 03:08:11 AM ---So the Comanche project is nearly complete just waiting a few parts to come it. ill have pics next week hopefully while its driving down the road.
--- End quote ---
Anything new? Where are those pictures?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version