The Mud Pit > General
jeep dead or atleast the d35 is
gearhead1985B:
--- Quote from: Mr Rock on July 08, 2010, 01:15:06 AM ---
Ok, Makes sense, i just wondered if you had found a prefit kit? The axle is out of an 84 Grand Waggy no disconnect.
--- End quote ---
really the disconect for the waggy's are in the diff (it has a funny looking diff cover same shape as the d44 but has a weird bulge in it) not on the axle like the yj
here is what i ground and how i mounted it i found the pic i thought i took
gearhead1985B:
as it sits right now 99" base and way to darn tall so step 2 of the lifting process lower the front end with smaller shackles and redrill the spring mounts the rear is about right as soon as i can figure out a way to get the shackel off the rear cross member any idears i are stumped i think boom shackles will still hit the frame i am going to add another leaf tomorrow and try some booms the toyota leaves are real soft and maybe notch the crossmember a little
get and mount the 35's sell the 33's find used 38's tsl/ltb/booger and regear to 4.88 or steaper with a locker in the front and cutting breaks in the rear call it good till i blow another axle to shreads then on to custom 609's
and i trying to figure out how to trim the rear so that i will not have to comp cut a still get full flex
gearhead1985B:
yesterday i got my rear finders trimmed and here is how it turned out
here is a mid way throught pic i took and made a card board template a half inch or so bigger than what i wanted to cut and transferd that on to the body then cut the template out and drew a line a half inch above where i cut and bent up to that line with pliers and a hammer
Mr Rock:
--- Quote from: gearhead1985B on July 08, 2010, 03:44:50 AM ---really the disconect for the waggy's are in the diff (it has a funny looking diff cover same shape as the d44 but has a weird bulge in it) not on the axle like the yj
here is what i ground and how i mounted it i found the pic i thought i took
--- End quote ---
Is this bump you are talking about on the diff its self or on the cover? How does it engage?
gearhead1985B:
--- Quote from: Mr Rock on July 11, 2010, 05:47:16 PM ---
--- Quote from: gearhead1985B on July 08, 2010, 03:44:50 AM ---really the disconect for the waggy's are in the diff (it has a funny looking diff cover same shape as the d44 but has a weird bulge in it) not on the axle like the yj
here is what i ground and how i mounted it i found the pic i thought i took
--- End quote ---
Is this bump you are talking about on the diff its self or on the cover? How does it engage?
--- End quote ---
no that is how much i ground down to make the perch fit from what i under stand there is a bulge in the diff cover with 2 vaccume ports on it and the vaccume disconect is in side the diff i seen one in a jy and left it cause i did not know what it was i would check ifsj.org for all kinds of info on that axle
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version