The Mud Pit > General

jeep dead or atleast the d35 is

<< < (4/8) > >>

BlacXJeep:
follow the illinois rules. soldiers and sailors act. as long as you are registered there. right?

Mr Rock:

--- Quote from: gearhead1985B on July 06, 2010, 02:44:34 PM ---well front is done i can clear 40's with 5" of up travel i am on the process now trying to lower my heep at least 2" here are  a few pics the cj is my buddys cj8 with a 4" spring and 3" body on 35's



this thing is a pita to get into my leg don't go that high and i got pulled over just so the cop could look at my lift and suspension i am too tall it looks like i will be frenching the spring hangers

--- End quote ---

I picked up a D44 waggy front axle and was thinking about doing a SOA. What did you use for the front spring perch? how did you keep your geometry correct?

gearhead1985B:

--- Quote from: Mr Rock on July 06, 2010, 09:36:34 PM ---
I picked up a D44 waggy front axle and was thinking about doing a SOA. What did you use for the front spring perch? how did you keep your geometry correct?

--- End quote ---

what year waggy d44 80-86 are a vaccume diconect axle

for my geometry i ground into the housing some and i have no problems yet but i don't have a front ds in so idk if i will have ds vibs but to weld it in i left the stock perches intact leveled the axle and ground the perches to fit setting the passenger side first and then measured off the ground for a hieght and then ground the driver side so it was level and the same hight as the passenger side and then welded it up does that make since

gearhead1985B:

--- Quote from: BlacXJeep on July 06, 2010, 09:32:14 PM ---follow the illinois rules. soldiers and sailors act. as long as you are registered there. right?

--- End quote ---

yeah i am no where close to leagle for that but what the 5.0 don't know don't hurt them

Mr Rock:

--- Quote from: gearhead1985B on July 07, 2010, 03:54:12 AM ---what year waggy d44 80-86 are a vaccume diconect axle

--- End quote ---

Ok, Makes sense, i just wondered if you had found a prefit kit? The axle is out of an 84 Grand Waggy no disconnect.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version