The Mud Pit > General

NP 241bolt

(1/2) > >>

Flex:
anyone know if a Np241 out of a Rubicon will bolt into a XJ, i know it has 4:1 and a fixed yoke, right?

BlacXJeep:
I have heard of this before think its been done

calvynandhobbs:
I just went over to NAXJA and tried looking around. I found several threads where people swapped in a 241 from a Rubicon with AX15 transmissions to XJs with AX15s, but I couldn't find anything about the automatic. It looks like it is a complete bolt in for manuals, but not too sure on putting one behind a AW4.

Flex:
well the the np 231 is the exact same between automatics and manual so i would assume that it would swap right over.

So am i correct to believe that has the 4:1 low and a fixed output

calvynandhobbs:

--- Quote from: Flex on March 17, 2010, 06:37:13 PM ---well the the np 231 is the exact same between automatics and manual so i would assume that it would swap right over.

So am i correct to believe that has the 4:1 low and a fixed output

--- End quote ---

As far as I can tell you are correct in that it has the 4:1 and a fixed output. I have added a link to a small write up on NAXJA. Everything appears to be bolt in except switching out yokes.

http://www.naxja.org/forum/showthread.php?t=941891&highlight=nv241

Navigation

[0] Message Index

[#] Next page