The Mud Pit > Wrenching
Ford 8.8 axle swap
HOT-ROD:
justin,
you're doing fine.
now, all you need is to get a plum bob, a sextant, and a lazer studfinder with a bias axle level so you can hang everything with lazer precision.lol
oh yeah,
CUT IT!!!!!
Axle:
I think I will leave it bare until after the welding is done. If any rust shows up between now and then, I'll just scrape it off before I paint.
albsvx:
you should herculine it ... that'd be sweet! (after the welding is done of course)
is it going to be sitting outside for the next month?
personally, I would prime it all, especially the parts that you've ground down to bare metal (where the brackets were) ... you can always give it a quick hit with the grinder to get back to metal when welding time comes
rocket:
i agree w/ al. bare metal rusts quick here, esp if the humidity is high.
HOT-ROD:
powdercoat it!!!!!!!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version