The Mud Pit > Wrenching

Dana 30 axle seal leaking?

<< < (2/2)

PaulW:

--- Quote from: kirksjeep on August 01, 2009, 05:13:25 AM ---It might also be a good time to look into new U-joints while you have the shafts out.  I have a few tricks that might save some time pulling the axle shafts.  I'll show you the tricks when you stop by.

--- End quote ---

i leave them attached to the hubs.  just take out the 3 bolts and smash the bearings out with the axle in it, remove em as 1 piece.  it should take about 20-75 minutes depending upon how much rust is there lol.

Navigation

[0] Message Index

[*] Previous page