Christmas time in July

[footman]

I'll be wrenching all day next tuesday (8/11) if anyone wants to stop by and get their hands dirty.
I'll be at my place in Groton, PM me for directions.

[PaulW]

I'll be wrenching all day next tuesday (8/11) if anyone wants to stop by and get their hands dirty.
I'll be at my place in Groton, PM me for directions.

i may just take you up on that.

[footman]

Sweet Paul. Ill send you a pm

[PaulW]

all depends upon what my work schedule looks like

[kirksjeep]

Steve- do you have air tools??  If not, we can do your work in my shop.  I'm about 20 min. from Groton, but I would be closer for Paul to come help. I also have a welder, a ton of power tools, a couple of floor jacks, jack stands..... basically I should have everything we would need. 

[footman]

Hey Kirk, I do have all the air tools. 
Thank you for the offer to use your house.  I'd like to do it at my house just in case I cant finish it or I run into any problems(NAPA, AZ are just down the street).  Plus I'm going to start late monday night painting the rails with POR15 and possibly start getting it prepped for Tues morn (I plan on jumping on it around 7am).  I'll have to leave the Jeep and drive the Truck loaded with all the goodies.

[calvynandhobbs]

Steve, I should be able to come by for a couple hours after work. Send me your address.

[kirksjeep]

If you have air tools that will make things much easier.     What year is your TJ?  In 2000 () Jeep added a harmonic dampener to the end of the transfer case, and it requires 3 metric size bolts to pull it.

[BayouGold]

Steve, I should be able to come by for a couple hours after work. Send me your address.

x2

[PaulW]

basically I should have everything we would need. 

blinker fluid recharge kit??  was a sir charge from the flux capicitor master install kit.  also came with extra muffler bearings.

[PaulW]

I also have a welder...

THREAD HIJACK... What kind??

Steve answer my pm and we'll see what we can do.  I may be there as early as 9:30.

[footman]

Hey paul, did you get the PM?
I also have a welder and this will be its virgin use!!!!!!!
Kirk, its a 99 no balancer.
I've got instuctions for everything so I'll layout my tools and make sure I have everything.
I may need a drill that takes larger bits.

[PaulW]

Hey paul, did you get the PM?
I also have a welder and this will be its virgin use!!!!!!!
Kirk, its a 99 no balancer.
I've got instuctions for everything so I'll layout my tools and make sure I have everything.
I may need a drill that takes larger bits.

how large of a drill do you need??  i have a half inch cordless ryobi, and a corded 1/2" dewalt that is nasty, and a hilti hammer drill that will put 3" holes in cement.

[footman]

I believe the largest hole I have to drill something like 29/32 or something ridiculous like that then there is a slightly smaller than that

[PaulW]

I believe the largest hole I have to drill something like 29/32 or something ridiculous like that then there is a slightly smaller than that

then a drill with a 1/2" chuck should be alright.