The Mud Pit > Wrenching
Starter wont start
rocket:
have you checked your battery connections?
footman:
Do you know how to test if the clutch pedel position sensor is good
rocket:
--- Quote from: footman on April 26, 2009, 02:51:29 PM ---Do you know how to test if the clutch pedel position sensor is good
--- End quote ---
put an ohm meter on both ends of the switch. puch the clutch. if reading goes from infiinity (usually a -0 on a digital meter) to zero, it works.
footman:
Paul, much thanks for coming over and finding my electrical gremlin.
kirksjeep:
What was the problem? If you look at the diagram the block on the left side, second from the top...labeled fuse block. If you look in the owners manual it will tell you the fuse number, but if you insert this fuse it will bypass your clutch switch safety feature. More importantly it will allow the starter motor to pull you up a short hill if the engine won't start. Just remember you disabled a safety feature and make sure your Jeep is in neutral/ or you step on the clutch before you start it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version