The Mud Pit > Wrenching
Tummy Tuck
footman:
Hey Scott I was thinking of using my new welder to make a flat belly skid. 1/4" plate with some 1/2" square stock on either side to counter sink the bolts. Some angle iron for bracing and wallah. I already have the BL and the MML, I would just have to finally get my SYE and CV shaft. I've found the scamatics on line for this exact process. It gives alot of extra clearance.
Seabee_BUC:
Sweet... I found one today too but would need the BL and MML...
kirksjeep:
By adding the BL and MML, you should have the room for the tummy tuck, but you also can mod the gas tank skid to tuck it up an inch higher too. It's all on my list when I have the $$ and time.
footman:
Ditto on the list. Thats why I'd like to buy the gas skid and make the TT.
CnoteTJ:
they must have changed the design a little, mine doesnt have that hump on the back end for the t case
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version