The Mud Pit > Wrenching
Ball joint advice
rocket:
the haynes manual didn't specify which way to push?
PaulW:
--- Quote from: rocket on February 28, 2009, 05:31:32 PM ---the haynes manual didn't specify which way to push?
--- End quote ---
hehe that sounds dirty :D
phoenix:
--- Quote from: PaulW on February 28, 2009, 04:54:15 PM ---
I have the OTC ball joint master kit if you want to use it.
--- End quote ---
Can you explain a bit? Is this to install, remove, or both? Heck, you are close enough for me to take a ride! lol
--- Quote from: rocket on February 28, 2009, 05:31:32 PM ---the haynes manual didn't specify which way to push?
--- End quote ---
No, just says to push till it was in. ;D ;D ;D
PaulW:
--- Quote from: phoenix on March 01, 2009, 01:19:54 AM ---
--- Quote from: PaulW on February 28, 2009, 04:54:15 PM ---
I have the OTC ball joint master kit if you want to use it.
--- End quote ---
Can you explain a bit? Is this to install, remove, or both? Heck, you are close enough for me to take a ride! lol
--- Quote from: rocket on February 28, 2009, 05:31:32 PM ---the haynes manual didn't specify which way to push?
--- End quote ---
No, just says to push till it was in. ;D ;D ;D
--- End quote ---
It installs, and removes ball joints in pretty much every application that uses pressed in ball joints. GM FORD CHRYSLER, Mercedes, all of them. Need to use it pm me. My toolbox is in storage at a friends house in Cromwell, so I'd just have to run over and grab it for ya. I even have the instructions still on how to use it if it'll help.
phoenix:
Cool, will let you know in a couple days.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version