The Mud Pit > Trading Post

Wanted: 1/8" plate (small peices)

<< < (2/3) > >>

rocket:
If i can't get stuff local, i'll have too.  i know I can get pipe at HD, and maybe some small plates, too.

WillC:
I have an old sailboat cradle here in New London it is made up of heavy angle iron ( 3x3x1/4 ), u-channel ( 1.5x6" or 8" x 8') and pipe ( 3"x 3 or 4')
all the sizes are guesses as I do not want to go out in the snow and measure it.
The cradle is bolted together but has been sitting for a few years and is a little rusty, it should un-bolt or cut it up with a sawsall.
You must take it all, bring a pickup, a lot of free steel, the u-channels would make good bumpers.

Will C

PaulW:
I think i still have a sheet of 1/8" i'll check the garage later today.

WillC:
The u-channles would also make excellent ramps to move a lathe up bulk head stairs.
 

calvynandhobbs:
Will, I want to set up a time to look at the steel you have. I may be able to use that for building my rear bumper. I'll send you a pm.

Navigation

[0] Message Index

[#] Next page

[*] Previous page