The Mud Pit > Wrenching
Taco Dell
rocket:
So, after painting all my rusty/bare/exposed metal, I decied to straighten my skid. Fail! Then I decided to lube the drive-line. One zirk is sheared off :( Since I'm done wheeling for a while, I though I should re-connect my anti-sway bar. The one bolt of one link that was still on, is frozen solid! The inside hex is stripped, and my nut splitter wont crack it.I know I can cut the whole thing off w/ a cut-off wheel, but :'(
anyone have access to a big metal press to flatten my skid out?
Seabee_BUC:
I have a big effin' hammer here at the shop...LOL
jmwendler:
I should have my big hydrolic press here after the holidays. Might even have it before the weekend is here. It currently is in storage and I sign the lease for my new place on Thursday. I have not set up the reciept of my HHG yet. Will let you know when I have it. The supports are about 2.5ft wide, guessing. Not sure how wide your skid is.
Tie Rod
Axle:
--- Quote from: jmwendler on December 15, 2008, 03:47:05 PM ---Tie Rod
--- End quote ---
How appropriate! ::) ;D
Seabee_BUC:
Can we get the webmaster to change his screen name??? LOL
Navigation
[0] Message Index
[#] Next page
Go to full version